If your room is wider than the shower base, fur in the walls as needed to butt against the ends of the shower base (see Photo 14). Our bathroom is 6 ft. wide, so we added a floor-to-ceiling 2×6 wall at the showerhead end and a shorter 2×6 wall at the opposite end. We made that wall only 43 in. above the floor so we could use the top of the wall to hold shampoo and other shower supplies. The shower base usually comes with a special 2-in. drain fitting that you connect to the drain line (Fig. B).
Although this new bathroom is a bit smaller because of additional plumbing walls, it appears larger. Substituting a shower for the bathtub, adding a large mirror, and using a wall-hung sink and toilet all contribute to the spacious feeling. This big-picture stuff is striking, but it’s the step-by-step details that make this small bathroom remodel work. We cover the little kernels of information that will help your project go more smoothly and with fewer headaches.
Framing rough-in. This refers to any structural framing work that is required. Low-level remodels may require no rough-in framing at all, while others may involve work like framing in a new shower stall. While some skills are involved, DIYers can usually do this work if they have moderately good carpentry skills. The framing rough-in may require an inspection to make sure the work is done correctly.
To begin, rip the top and side jambs to the thickness of the wall framing plus the exterior wall sheathing. The cement board will lap over the jambs. The windowsill should also be flush with the interior framing, but hang over the outside sheathing about 1-1/2 in. and have a 5-degree slope toward the outside to help shed water. To keep water from running behind the siding as it drips off the edge, cut a shallow groove (or saw kerf) in the bottom lip (Fig. A). Also, remember to flash behind the trim to keep the window watertight. Trim the window exterior to match the house, using caulk to seal between the trim and siding.
There is nothing better than getting into a hot shower at the end of a long day. My husband and I have been wanting to do some remodeling to our master bathroom and I would love to have any one of these designs. They look so functional for their size and I love the shower doors in some of these designs! These have given me some great ideas, thanks for sharing!
There is no way around it: it costs more to remodel quickly than it does to take your time. This is primarily because a quick remodel really requires a general contractor (GC) to coordinate the project with various subcontractors (plumbers, electricians, tiling contractors), and you are paying for the general contractor's skill and experience. While it is possible for a homeowner to serve as his or her own general contractor—interviewing, hiring, supervising, and paying individual professionals to do their work in order—this is always a slower process than allowing a GC to coordinate his preferred subcontractors. Hiring your own subcontractors, though, can save you quite a bit of money, as you eliminate the time and overhead of the general contractor.
Bathroom Renovations Sydney is a highly professional and reliable company. The team that they sent for my bathroom renovation was quite friendly, cooperative, and hard working. They hardly made a mess and ensured a clean working environment at all times. Everything went along very smoothly from the start and I am completely satisfied with the results that they have delivered. Thanks a bundle for the great service!
Demolition. All remodeling jobs start with tearing out and removing elements that will be replaced. Depending on the level of your remodeling job, this can be a simple matter of removing old fixtures and flooring, or as complicated as removing everything down to the wall studs and floor joists. Either way, this can be hard work but it is not difficult, and most homeowners can do this work themselves to save money. Most demolition can be done in a weekend. You will need to rent a roll-off dumpster or arrange for a disposal company to take away a pile of demolition debris.
There are also contractors who are perfectly willing to split the work with energetic and skilled homeowners. You can, for example, offer to do all the demolition and painting/finishing work yourself, in exchange for a discounted bid from a general contractor. And if there are other tasks you are able and willing to take on, discuss this with your contractor. But make sure to discuss it upfront. Time is money for a general contractor, and he will not want his progress delayed while a homeowner dawdles over installing the ceramic tile floor, for example.
In an ingenious turn, an inexpensive nightstand was turned into a vanity. It's a sophisticated alternative to a stock vanity and offers the look of a higher-end model. The nightstand drawer is still functional and can be used to store small items. A large above-counter sink minimizes splashing, and the nightstand was treated with a lacquer finish to make it water-resistant.
Renovating the laundry room from time to time can be a refreshing experience and if you are looking to get your laundry renovated then this service is just for you. With our laundry renovations services, we help your laundry blend in perfectly with your home and design it so that you can wash, fold, iron, hang, or store laundry comfortable and with a peace of mind.
With it's black and white tiles and lavender walls, it looks like two bathrooms were squeezed into one. There was definitely a whole lot of clashing visions going on here.
Related: How to Refresh Your Bathroom for Less Than $100
Drywall installation. Most remodeling jobs will involve opening up at least some of the walls and ceilings, and after the plumbing and wiring rough-ins have been inspected and passed, a drywall pro or DIYer can then install and finish the drywall. This is somewhat tedious work, but it is well within the skill level of most DIYers. The money-savings here are modest, though, because professional drywall installation is not pricey.