Framing rough-in. This refers to any structural framing work that is required. Low-level remodels may require no rough-in framing at all, while others may involve work like framing in a new shower stall. While some skills are involved, DIYers can usually do this work if they have moderately good carpentry skills. The framing rough-in may require an inspection to make sure the work is done correctly.
Our service is renowned for providing high-quality bathroom renovations for amazing prices. Even though the cost of individual projects can vary greatly, we can do a complete makeover of your old bathroom for as little as $10,000. If you will need just a re-installation/removal of appliances and fittings then these costs can be even lower. We guarantee you that Bathroom Renovations Sydney will always offer you the most affordable prices for your renovations job!
Industrial bathrooms design are trendy. It usually uses rouge materials, woods, and visible bricks. Some industrial furniture like lamps for lighting also gives a proper look for this design. Just like this mid-sized bathroom, it has a marble tile porcelain floor and gray walls. Therefore, the colors and accessories applied here make the industrial bathrooms design looks obvious.
The wall behind the toilet can be almost any height. For a standard toilet height of 15 in., make the wall a minimum height of 43 in. If you’d like a higher toilet, make the wall that much higher. Or, make the wall go all the way to the ceiling. We built a short wall to conserve space and to create a shelf and a mirror alcove. The wall at the opposite end of the shower can be any height as well. We made it the same height as the toilet/sink wall so we could line up the accent tile and make a convenient shower shelf.
For your remodeled bathroom to operate well, it’s critical to install vent and drain lines of the proper size and slope. Use a 2-in. line to drain the shower and 1-1/2-in. line to drain the sink. The vents for the sink and shower can be 1-1/2-in. pipes, but a toilet should be vented with at least 2-in. material. Make sure that the drain lines drop 1/4 in. for every foot of travel toward the main stack.
If your room is wider than the shower base, fur in the walls as needed to butt against the ends of the shower base (see Photo 14). Our bathroom is 6 ft. wide, so we added a floor-to-ceiling 2×6 wall at the showerhead end and a shorter 2×6 wall at the opposite end. We made that wall only 43 in. above the floor so we could use the top of the wall to hold shampoo and other shower supplies. The shower base usually comes with a special 2-in. drain fitting that you connect to the drain line (Fig. B).
Many factors that can influence the cost of a bathroom renovation project. This is the reason it is difficult to provide an estimate of the cost. For instance, if you only need a re-installation of tiles/bathroom accessories then the costs will be much lower to a complete bathroom renovation project that involves structural changes. If you would like to learn how much your bathroom renovations will cost, reach out to our team with your requirements and we will get back to you with a free quotation.