BH&G is part of the Meredith Home Group. © Copyright 2019 Meredith Corporation. All Rights Reserved. Privacy Policythis link opens in a new tab Data Policythis link opens in a new tab Terms of Servicethis link opens in a new tab Ad Choicesthis link opens in a new tab EU Data Subject Requeststhis link opens in a new tab Cookie Preferencesthis link opens a modal window Web Accessibilitythis link opens in a new tab
Yes, a bathroom remodel can greatly boost the value of your home or office. Often, one of the key factors that go into the valuation of a home or office is the number of bathrooms and the current state of the bathroom. By having your bathrooms renovated and remodeled to a modern luxurious bathroom, you can not just increase the value of your home or office but will also show to potential buyers how much care you have taken of the entire place.
By clicking View ProsView Matching Pros, you affirm you have read and agree to the HomeAdvisor Terms, and you agree and authorize HomeAdvisor and its affiliates, and their networks of Service Professionals, to deliver marketing calls or texts using automated technology to the number you provided above regarding your project and other home services offers. Consent is not a condition of purchase.
To begin, rip the top and side jambs to the thickness of the wall framing plus the exterior wall sheathing. The cement board will lap over the jambs. The windowsill should also be flush with the interior framing, but hang over the outside sheathing about 1-1/2 in. and have a 5-degree slope toward the outside to help shed water. To keep water from running behind the siding as it drips off the edge, cut a shallow groove (or saw kerf) in the bottom lip (Fig. A). Also, remember to flash behind the trim to keep the window watertight. Trim the window exterior to match the house, using caulk to seal between the trim and siding.
The wall-hung toilet’s supply line must have a male adapter with a temporary galvanized cap. Check the instructions on the toilet to get the proper location. Routing water supply lines is different in every bathroom, so you’ll have to adapt runs to your situation. But run the plastic drain lines and vents before starting any supply work. It’s much easier to route water supply lines around drain lines than to route drains and vents around supply lines. The same thinking applies to electrical work: Wait until the water supply work is finished before wiring.
Electrical rough-in. This is another task that should be left in the hands of pros unless you are one of the very few DIYers who are experts at it. A licensed electrician will run new circuits where required, install lighting and vent fans, and will arrange for the work to be inspected. Later, after the inspection is complete and the walls and ceilings are finished, the electrician will return to hook-up outlets, light fixtures, and fans. Two inspections are required: one at the rough-in phase, another after the final installation. 

My experience with Bathroom Renovations Sydney was quite pleasant. The team of workers they sent over were very knowledgeable and professional and had everything planned out from the demolition to the finishing. Each subcontractor in their team was capable, courteous, and cooperative. The consistency in their work through the renovation and the quality of work that they delivered was simply exceptional. I am very delighted with the results and my bathroom looks as great as well. Thank you so much for all the hard work!
The cost of a bathroom renovation in Sydney can greatly change depending on your exact requirements e.g. Do you need structural changes? Do you need new accessories? However, an average bathroom renovations project that involves a complete makeover for your bathroom can vary between $15,000 to $25,000. We would still recommend that you get in touch with our representatives who can better understand your specific requirements and provide you with an accurate cost breakdown.

Glass block comes in 8-in. and 6-in. squares and 4 x 8-in. half-block rectangles. You’ll need to choose between real mortar grout joints and clear silicone–joined blocks. We chose the silicone system because we liked the clean, uninterrupted look. Whichever way you go, buy the panel preassembled and banded together as one unit, ready to set into the opening.
For the most part, that means moving the GFCIs (Ground Fault Circuit Interrupters) and other power outlets so that they line up with your new vanity and cabinets. After all, you don’t want to have to reach down next to the toilet in order to plug in your hair dryer. You should call in an electrician for this step, especially if you have never worked with home wiring before.
Drywall installation. Most remodeling jobs will involve opening up at least some of the walls and ceilings, and after the plumbing and wiring rough-ins have been inspected and passed, a drywall pro or DIYer can then install and finish the drywall. This is somewhat tedious work, but it is well within the skill level of most DIYers. The money-savings here are modest, though, because professional drywall installation is not pricey. 
×