Renovating the laundry room from time to time can be a refreshing experience and if you are looking to get your laundry renovated then this service is just for you. With our laundry renovations services, we help your laundry blend in perfectly with your home and design it so that you can wash, fold, iron, hang, or store laundry comfortable and with a peace of mind.
To begin, rip the top and side jambs to the thickness of the wall framing plus the exterior wall sheathing. The cement board will lap over the jambs. The windowsill should also be flush with the interior framing, but hang over the outside sheathing about 1-1/2 in. and have a 5-degree slope toward the outside to help shed water. To keep water from running behind the siding as it drips off the edge, cut a shallow groove (or saw kerf) in the bottom lip (Fig. A). Also, remember to flash behind the trim to keep the window watertight. Trim the window exterior to match the house, using caulk to seal between the trim and siding.
Disconnect the trap from the tub, remove any clips, fasteners or screws that hold the tub to the wall, and demolish the old cast iron tub with a sledgehammer. Remove the sink and toilet. Turn off the electricity at the main panel and remove light fixtures. Cap the wires with wire connectors. Then rip out the wall finishes and surfaces clean down to the studs and pull out any insulation. If your ceiling is in good shape, use a utility knife to cut the drywall along the edges so the wall materials will separate cleanly from the ceiling.
If your small bathroom is bursting with anything, let it be a personality (rather than stray makeup and toiletries). This girly, floral bathroom from At Home With Ashley uses a vintage-inspired wallpaper to add pops of color to an otherwise neutral white space. While wallpaper can be expensive, one benefit of a small space is that you won't need to purchase much in order to make a big statement.

Tear out the existing piping (Photos 5 and 6). Then frame the 2×6 walls that will contain the new plumbing and the opposite end of the shower base (Photos 8, 9 and 14). It’s easiest to nail the bottom plate to the floor and the top plate to the ceiling, then fill in the studs one at a time by toenailing them in at the top and bottom. Stack the studs directly in front of the old ones wherever possible. Space the studs in the center of the shower about 12 in. apart to leave room for the shower valve and showerhead. The studs behind the toilet should be spaced exactly 19-3/4 in. apart for securing this toilet chair carrier (Photos 8 and 15).

With the rough plumbing complete and the toilet chair carrier in position, finish the electrical and add blocks as needed to support the sink (Photo 15), towel bars, grab bars, etc. Then close up the walls. We recommend cement board for durable tile walls and floors, but other tile backers are available at tile shops. Here are key installation tips:


We understand how important it is to get your renovations completed on time particularly when the bathroom being constructed or renovated is used regularly. This is the reason we allocate professionals who are reliable and efficient to handle your renovations job for you so that all work from the planning to the finishing is completed within your time constraints.

Framing rough-in. This refers to any structural framing work that is required. Low-level remodels may require no rough-in framing at all, while others may involve work like framing in a new shower stall. While some skills are involved, DIYers can usually do this work if they have moderately good carpentry skills. The framing rough-in may require an inspection to make sure the work is done correctly. 
One of the best aspects of modern, contemporary design is the seamless, clean lines that create an open and airy feel. This updated bathroom from OneKindesign feels much bigger than it actually is, in part because the eye is drawn to the crisp, straight lines of the vanity, which elongates the room and almost seem to push the walls out. Neutral colors such as white and unpainted wood are also great choices for small bathrooms.
It's hard to believe this is the same bathroom! Light and airy with a pop of colour thanks to the wall art, this chic soaking tub leaves plenty of room for the standing shower and various knick knacks.

Related: 9 Major Mistakes to Avoid When Renovating Your Bathroom

With the rough plumbing complete and the toilet chair carrier in position, finish the electrical and add blocks as needed to support the sink (Photo 15), towel bars, grab bars, etc. Then close up the walls. We recommend cement board for durable tile walls and floors, but other tile backers are available at tile shops. Here are key installation tips:
A DIY bathroom makeover is not complete without new floor tiles. But before you start grinding away with the grouting, use a mason’s chalk line to mark reference lines perpendicular (at a 90-degree angle) to the wall with the longest continuous line. This will allow you to keep your tiles in a straight line, avoiding the dreaded crooked tiling job.
×