Glass block comes in 8-in. and 6-in. squares and 4 x 8-in. half-block rectangles. You’ll need to choose between real mortar grout joints and clear silicone–joined blocks. We chose the silicone system because we liked the clean, uninterrupted look. Whichever way you go, buy the panel preassembled and banded together as one unit, ready to set into the opening.
Bathroom remodels provide 60 to 70 percent resale returns as a home improvement project. However, this project isn’t cheap. It is essential to plan your remodeling ideas ahead of time. Then, hire a remodeling contractor for the job. Ask questions, set realistic expectations, get accurate cost estimates and budgeting from the start. Also spend time learning how to work with a bathroom contractor.
To begin, rip the top and side jambs to the thickness of the wall framing plus the exterior wall sheathing. The cement board will lap over the jambs. The windowsill should also be flush with the interior framing, but hang over the outside sheathing about 1-1/2 in. and have a 5-degree slope toward the outside to help shed water. To keep water from running behind the siding as it drips off the edge, cut a shallow groove (or saw kerf) in the bottom lip (Fig. A). Also, remember to flash behind the trim to keep the window watertight. Trim the window exterior to match the house, using caulk to seal between the trim and siding.

Fixture hookup. The final step is for the plumber and electrician to return to install the various fixtures and make the plumbing and wiring connections. There is an inherent hazard with any plumbing and wiring work, but when pros have run the plumbing and wiring inside the walls, the final hookups are well within the skill range of experienced DIYers. Make sure, though, that the final installation is inspected. 
If your room is wider than the shower base, fur in the walls as needed to butt against the ends of the shower base (see Photo 14). Our bathroom is 6 ft. wide, so we added a floor-to-ceiling 2×6 wall at the showerhead end and a shorter 2×6 wall at the opposite end. We made that wall only 43 in. above the floor so we could use the top of the wall to hold shampoo and other shower supplies. The shower base usually comes with a special 2-in. drain fitting that you connect to the drain line (Fig. B).
Yes, all of our bathroom renovations projects are covered under a 7-year guarantee. We work with the best tradesmen and professionals in the industry to ensure that all work is done in compliance with the Australian building codes but at the same time, also provide guarantees for all work that we do. We are here to ensure the maximum satisfaction of our customers.
Here at Bathroom Renovations Sydney, we provide you with the complete range of bathroom renovations services for modern bathrooms, luxurious bathrooms, small bathrooms, and traditional bathrooms. Our complete renovations services include, but are not limited to, planning, designing, remodeling, construction, appliances removal/installation, fittings removal/installation, tiling, and paint. You can choose any one of these services, or our entire assortment of services to enjoy peace of mind with your renovation.
You’ll spend $3,000 to $8,000 on the typical remodel. Anywhere from 40 to 65 percent of a bath upgrade cost comes from labor. However, doing any project yourself means no insurance and added fees if something goes wrong. Hire a professional for any work you’re not comfortable doing, such as the plumbing and electrical. Consider the pros and cons of DIY vs professional bathroom remodeling.
×